You may rarely think about your home’s water heater, until it’s not there for you anymore. On average, a good water heater will last about 8 to 12 years. You can also expect it to account for about 15 percent of your utility bill.
Your final selection, after choosing type and size, will probably come down to brand and price, but don’t ignore the Energy Star sticker. Choosing a more efficient model, even at a slightly higher initial cost, will pay dividends for you in savings on your energy bill throughout the life of the appliance.
Most water heaters have a life span of eight to roughly fifteen years, depending on the make and model you purchased. Look at your records to see exactly when you purchased the water heater. If you purchased a home which included the water heater, it may be time to get a plumber out to look at the unit and determine if it is still in good functional condition and how much longer you may have. If you have a higher grade model installed, you may be able to get more life out of your heater, but that is not always a guarantee.
Softening hard water with salt is actually more damaging to anodes than the calcium carbonate–the cause of hard water. Salt can consume an anode up to three times faster than usual. Phosphates can have the same adverse affect on an anode. The anode should be inspected every two years or sooner if you use these water softening agents.
High water pressure can also destroy it. When the temperature or water relief valve starts to open and close, you must have your Water Heater Replacement Daytona Beach checked right away.
The water heater will only be protected if the anode rod has enough metal hanging on it. The steel core wire keeps the sacrificial metal on the anode. Be sure to inspect the anode for an exposed core wire every two years at least.
Let’s talk about maintenance. To maintain your water heater you should perform some important steps. Firstly, turn off the gas or electric power of the heater. After that, let the water be cooled. If it gets a little cold then close the incoming of the water valve. Then attach a hose to the drain valve to run the water into the large bucket or to a drain. This flushes the sediment which will make your heater last longer than normal.